Even though I disconnect iPad for a second try, the same issue happens again! I just can't restore iPad. But it just hung near the end of the progress bar for a long time. Let the iPad charge for at least 30 minutes before you use it again."Hey, I try to restore my iPad for personal reasons. Then the iPad will shut down and will not reboot again.You need quickly plug in the charger again because the home screen only appears in a flash. As soon as the Apple logo appears, unplug the charger.It will restart and you will see the Apple logo. Plug your USB charging cable to the wall power outlet.It has been proved to be helpful for some people. If your iPad turns on and off in a loop when it is charging or it has a low battery, here is a solution worth trying. iPad Stuck in Boot Loop When in Low Battery or Charging Your device will be restored, eventually, solving the iPad boot loop issue.Ĥ. Click on the 'Restore iPhone' button and confirm the action. Now, You'll get a pop-up that says your iPad is detected in Recovery mode.Now, let go of the 'Power' button and keep holding the 'Home' button till you see 'Connect to iTunes' screen on your iPad. Now, to put your device in recovery mode, push the 'Power' button along with the 'Home' button and keep them holding for 10 seconds. Launch the iTunes and connect your iPad to it.Please remember, this method will wipe off all your data on the iPad and restore it to factory settings. You can take the help of restoring your iPad via iTunes by entering Recovery mode to end the reboot loop issue with your iPad and bring your iPad back to normal. Restore iPad That Keeps Restarting using iTunes (Data Loss) Try iMyFone Fixppo now! It is compatible with iPadOS 14/13.ģ. Once the firmware is download, click "Start" and then Fixppo will begin repairing the iOS system.Ī few minutes later, your iPad will restart in normal mode. The downloading process shouldn't take long. All you have to do is to choose the version you like and click "Download". Once your iPad has been detected, the program will provide you with all the suitable firmware. Otherwise, you need to put your iPad into DFU or Recovery mode to get it detected. Some iPads stuck in a restarting loop can be recognized by Fixppo, then you can go to the next step. Connect your iPad to the computer using a USB cable. Launch it and from the main window, select "Standard Mode" from the 3 options. Download and install the program on your computer. ![]() How to Get Your iPad out of the Boot Loop using iMyFone Fixppo
0 Comments
Leave a Reply. |